1-113
Making Measurements
Using Test Sequencing
Loop counter decision making The analyzer has a numeric register called a loop
counter. The value of this register can be set by a sequence, and it can be incriminated or
decremented each time a sequence repeats itself. The decision making commands
and jump to another sequence if the
stated condition is true. When entered into the sequence, these commands require you to
enter the destination sequence. Either command can jump to another sequence, or restart
the current sequence.
As explained in "Embedding the Value of the Loop Counter in a Title" on page 1-106, the
loop counter value can be appended to a title. This allows customized titles for data
printouts or for data files saved to disk.
To Next Page
Loading...
Need help?
General
