Chapter 5 Error Messages
Calibration Errors
119
5
Calibration Errors
The following errors indicate failures that may occur during a calibration.
Refer to the
Service Guide
for more informati on.
701 Cal security disabled by jumper
The calibration security feature has been disabled with a jumper inside the
power supply . When applic able, this error will occ ur at power-on to wa rn you
that the power supply is unsecured.
702 Cal secured
The power supply is secured against cali bration .
703 Invalid secure code
An invalid calibration security code was received when attempting to unsecure
or secure the power supply . Y ou must use the same security code to unsecure
the power supply as was used to secure it, and vice versa. The security code
may contain up to 12 alphan umeric characters. The first character must be a
letter.
704 Secure code too long
A security code was received which co ntained more than 12 characters.
705 Cal aborted
A calibration in progress is aborted when y ou pre ss any front-panel key, send
a device clear, or change the local/remote state of the instrum ent.
708 Cal output disabled
Calibration is aborted by sending
OUTP OFF
command dur ing calibrating a
output.
712 Bad DAC cal data
The specified DAC calibration values (
CAL:VOLT
or
CAL:CURR
) are out of
range. Note that the new calibration constants are not stored in the non-volatile
memory.
713 Bad readback cal data
The specified readback calibration values (
CAL:VOLT
or
CAL:CURR
) are out
of range. Note that the new calibration constants are not stored in the non-
volatile memory.
To Next Page
Loading...
Need help?
General
