Chapter 5 Error Messages
Execution Errors
113
5
Execution Errors
-101 Invalid character
An invalid charact er wa s found in the command string. Y ou may have inserted
a character such as #, $, or % in the command keyword or within a parameter.
Exampl e:
OUTP:STAT #ON
-102 Syntax error
Invalid syntax was found in the command string. You may have inserted a blank
space before or after a colon in the command header, or before a comma.
Exampl e:
VOLT:LEV ,1
-103 Invalid separator
An invalid separator was found in the command string. You may have used a
comma instead of a colon, semicolon, or blank space - or you may have used
a blank space instead of a comma.
Exampl e:
TRIG:SOUR,BUS or APPL 1.0 1.0
-104 Data type error
The wrong parameter type was found in the com mand string. You may have
specified a number where a string was expected, or vice versa.
-105 GET not allowed
A Group E xecute Trigger (GET) is not allowed within a command string.
-108 Parameter not allowed
More parameters were received than expected for the command. You may
have entered an extra parameter , or you added a parameter to a command that
does not accept a parameter.
Exampl e:
APPL? 10
-109 M issing parameter
Fewer parameters were received than expected for the command. Y ou omitted
one or more param eters that are required for this command.
Exampl e:
APPL
To Next Page
Loading...
Need help?
General
