Chapter 1 General Information
Installation
7
1
Installation
Initial Inspection
W hen you receive your power supply, inspect it for any obvious damage that
may have oc curred during shipment. If any damage is f ound, notif y t he ca rrier
and the nearest Agilent Sales Office immediately. Warranty information is
show n in the front of thi s manual .
Keep the original packing materials in case the power supply has to be returned
to Agilent T echnologies in the future. If you return the power supply for service,
attach a tag identifying the owner and model number. Also include a brief
descriptio n of the prob lem.
Mechanical Check
This check confirm s that there are no broken keys or knob, that the cabinet
and panel surfaces are free of dents and scratches, and that the display is not
scratched or cracked.
Electrical Check
Chapter 2 describes an initial operation procedure which, when successfully
completed, verifies to a high level of confidence that the power supply is
operating in accordance with its specifications. Detailed electrical verification
procedures are included in the
Service Guide
.
Cooling and Location
Cooling
The power supply can operate without loss of performance withi n the
temperature range of 0 °C to 40 °C, and with derated output current from
40 °C to 55 ° C . A fan cools the power supply by drawing air through the rear
panel and exhausting it out the sides. Usi ng an Agilent rack mount wi ll not
im pede the flow of air.
Bench Operation
Your power supply must be installed in a loca tion that allows sufficient space
at the sides and rear of the power supply for adequate air circulation. The
rubber bumpers must be removed for rack mounting.
To Next Page
Loading...
Need help?
General
