208 Chapter 2
Front-Panel Key Reference
System (Local)
Key Access: System, Alignments
Load Defaults
Loads the default values for the alignment system,
turns on the frequency corrections, and resets the time
base to the factory values.
Align Now, All, will
automatically execute three times after pressing
Load
Defaults
.
Key Access:
System, Alignments
Remote Port
With Option A4H (GPIB and Parallel) only. Allows the GPIB address to
be entered. The default address is 18.
With Option 1AX (RS-232 and Parallel) only. Allows the baud rate to be
set. The available baud rate values are as follows: 110, 300, 600, 1200,
2400, 4800, 9600, 19200, 38400, 57600, 115200. The default baud rate is
9600.
Key Access:
System
Show System
Displays the number and description of the options installed in your
analyzer. It also displays the instrument model number, product
number, serial number, firmware revision number, Host ID (for
licensing), bootrom revision, and amount of RAM and ROM.
Key Access:
System, More
Prev Page
Allows you to access the previous page of show system.
It is grayed out if you are on the first page or only one
page exists.
Key Access:
System, More, Show System
Next Page
Allows you to access the next page of show system. It is
grayed out if you are on the last page or only one page
exists.
Key Access:
System, More, Show System
Show Hdwr
Gives detailed information about the hardware installed on your
analyzer.
Key Access:
System, More
Prev Page Allows you to access the previous page of show
hardware. It is grayed out if you are on the first page or
only one page exists.
Key Access:
System, More, Show Hdwr
Next Page
Allows you to access the next page of show hardware. It
is grayed out if you are on the last page or only one page
exists.
Key Access:
System, More, Show Hdwr
To Next Page
Loading...
