Agilent MOI for DisplayPort Cable & Connector Compliance Tests
3
6.3. Manual Setup for Frequency Domain Measurement .............................................. 35
6.3.1. Channel and Trace Settings ............................................................................. 35
6.3.2. Common Settings ............................................................................................ 36
6.3.3. Far End Noise (FEN) Measurement (Normative) ........................................... 36
6.3.4. Return Loss Measurement (Normative) .......................................................... 37
6.3.5. Insertion Loss Measurement (Normative) ....................................................... 37
6.3.6. Near End Noise (NEN) Measurement ............................................................. 37
6.4. Limit Test Settings .................................................................................................. 38
6.4.1. Displaying Judgment Result of Test ................................................................ 38
6.4.2. Setting the Warning Beeper ............................................................................. 38
6.4.3. Defining the Limit Line ................................................................................... 38
6.5. Calculating formula for Limit Line ........................................................................ 39
6.5.1. Bulk Cable and Connector Impedance ............................................................ 39
6.5.2. Insertion Loss .................................................................................................. 41
6.5.3. Return Loss ...................................................................................................... 42
6.5.4. Near End Noise (NEN) .................................................................................... 44
6.5.5. Far End Noise (FEN) ....................................................................................... 44
To Next Page
Loading...
Need help?
General
