Agilent MOI for DisplayPort Cable & Connector Compliance Tests
5
5. Test Procedure
5.1. Outline of Test Procedure
1. Connect 3.5 mm test cables to every test ports on the instrument.
2. Set measurement conditions.
3. Perform Calibration
4. Measurements and Data Analysis
Time Domain Measurements
- Bulk Cable and Connector Impedance Measurements (Normative).
- Intra-pair Skew Measurements (Normative).
- Inter-pair Skew Measurements (Normative).
Frequency Domain Measurements
- Insertion Loss Measurements (Normative).
- Return Loss Measurements (Normative).
- Near End Noise (NEN) Measurements.
- Far End Noise (FEN) Measurements (Normative).
Note: Hard Keys (Keys located on the Front panel of E5071C) are displayed in Blue color
and Bold. (Example: Avg, Analysis)
Note: Soft keys (Keys on the screen) are displayed in Bold. (Example: S11, Real, Transform)
Note: Buttons (in the TDR) are displayed in Green color and Bold. (Example: Trace, Rise
Time)
Note: Tabs (in the TDR) are displayed in Brown color and Bold. (Example: Setup, Trace
Control)
To Next Page
Loading...
Need help?
General
