Agilent Technologies E5071C Compliance Tests

Agilent MOI for DisplayPort Cable & Connector Compliance Tests
4
1. Modification Record
Revision
Comments
Issue Date
1.00
Initial Release.
Dec 15, 2008
2.00
Revised measurement procedure for the option TDR
Nov 1, 2010
3.00
Updated for the measurements requirements of Compliance
Test Specification Ver.1.2b
Jan 31, 2013
3.01
Update the model number of required test fixture.
Feb 18, 2013
2. Purpose
This test procedure was written to explain how to use the Agilent E5071C ENA Option
TDR to make the measurements required per VESA DisplayPort Standard Version 1,
Revision 2a.
3. References
VESA DisplayPort Standard Version 1, Revision 2a
VESA DisplayPort PHY Compliance Test Specification Version 1.2b
4. Resource Requirements
1. E5071C Network Analyzer with option TDR and option 4D5 or 4K5
2. Display Port test fixtures. BitifEye BIT-1050-0001-0, or an equivalent set of fixtures
and standards.
3. Four 3.5 mm cables 20 GHz bandwidth or equivalent
(Cables of equal length and characteristics must be used for all test ports)
4. 50 Ohm terminators to terminate unused channels (ex. Agilent 909D-301)

Agilent Technologies E5071C Specifications

General

Brand	Agilent Technologies
Model	E5071C
Category	Measuring Instruments
Language	English