Agilent Technologies ENA Series

Appendix C 171
COM Object Reference
SCPI.CALCulate(Ch).SELected.TRANsform.DISTance.STOP
SCPI.CALCulate(Ch).SELected.TRANsform.DISTance.ST
OP
Object type Property
Syntax SCPI.CALCulate(Ch).SELected.TRANsform.DISTance.STOP = Value
Val ue = SCPI.CALCulate(Ch).SELected.TRANsform.DISTance.STOP
Description For the active trace of channels 1 to 4 (Ch), sets the stop value of the fault location display.
Variable
For information on the variable (Ch), see Table C-2, “Variable (Ch),” on page 159.
Examples Dim Span As Double
SCPI.CALCulate(1).PARameter(1).SELect
SCPI.CALCulate(1).SELected.TRANsform.DISTance.STOP = 2E-8
Cent = SCPI.CALCulate(1).SELected.TRANsform.DISTance.STOP
Related objects SCPI.CALCulate(Ch).SELected.TRANsform.DISTance.STARt on page 167
SCPI.CALCulate(Ch).SELected.TRANsform.DISTance.STATe on page 168
Equivalent key [Analysis] - Fault Location - Stop
Value
Description Stop value
Data type Double precision floating point type (Double)
Range Varies depending on the frequency span, velocity factor, distance unit, and the number of
points.
Preset value 9.8357Ft or 2.9979m
Unit Ft (Feet) or m (Meters)
Note If the specified variable is out of the allowable setup range, the minimum value (if the lower
limit of the range is not reached) or the maximum value (if the upper limit of the range is
exceeded) is set.