Chapter 3 39
Making Fault Location Measurements
Basic Measurement Procedures
Basic Measurement Procedures
A typical fault location measurement consists of the following steps:
1. Enabling the fault location function
2. Selecting the transformation types
3. Calculating the measurement conditions
4. Setting the window
5. Setting the frequency range and the number of points
6. Setting the velocity factor
7. Setting the cable loss
8. Setting the display range
9. Calibrate the analyzer
10. Connect the cable under test
Each step is described on the following pages. The VBA utility program, which
facilitates measurement setup, is explained at the end of this chapter.
To Next Page
Loading...
