Agilent Technologies ENA Series

180 Appendix C
COM Object Reference
SCPI.CALCulate(Ch).SELected.TRANsform.TIME.STARt
SCPI.CALCulate(Ch).SELected.TRANsform.TIME.STARt
Object type Property
Syntax SCPI.CALCulate(Ch).SELected.TRANsform.TIME.STARt = Value
Val ue = SCPI.CALCulate(Ch).SELected.TRANsform.TIME.STARt
Description For the active trace of channels 1 to 4 (Ch), sets the start value used for the transformation
function of the fault location function.
Variable
For information on the variable (Ch), see Table C-2, “Variable (Ch),” on page 159.
Examples Dim Star As Double
SCPI.CALCulate(1).PARameter(1).SELect
SCPI.CALCulate(1).SELected.TRANsform.TIME.STARt = 0
Star = SCPI.CALCulate(1).SELected.TRANsform.TIME.STARt
Related objects SCPI.CALCulate(Ch).SELected.TRANsform.TIME.STOP on page 184
SCPI.CALCulate(Ch).SELected.TRANsform.TIME.STATe on page 181
Equivalent key [Analysis] - Fault Location - Start
Value
Description Start value
Data type Double precision floating point type (Double)
Range Varies depending on the frequency span and the number of points.
Preset value -1E-8
Unit s (second)
Note If the specified variable is out of the allowable setup range, the minimum value (if the lower
limit of the range is not reached) or the maximum value (if the upper limit of the range is
exceeded) is set.