Agilent Technologies ENA Series

198
Index
SCPI.CALCulate(Ch).TRANsform.METHod, 187
COM object
conversion rules from SCPI commands, 155
object model, 154
COM object reference
notational rules, 156
Command list by front panel key, 141, 151
Command list by function, 140, 150
Command tree, 142, 152
compressed cable, 32
conductor, cut, 34
conductor, dented, 34
connector effects, removing, 22
connector length, 25
connector model, 66
connector model feature, 67
connector model, shunt-C, 24
connector problems, potential, 79
contamination, cable dielectric, 33
correction, 52, 62
cut cable outer conductor, 34
cut outer conductor, 34
D
data correction, 87
deformed cable, 32
dented cable outer conductor, 34
dented outer conductor, 34
description
COM Object reference, 156
diagram
setup for fault location measurements, 54
setup for SRL measurements, 65
dielectric contamination, 33
directivity, 63
discrete cable faults, 22
distance and frequency span interactions, 12
distance measurements, theory, 12
distance vs bandwidth (in feet)
graph, 98
distance vs bandwidth (in meters)
graph, 101
distance vs resolution (in feet)
table, 97
distance vs resolution (in meters)
table, 100
dynamic range, 87
E
equipment setup
fault location, 54
SRL, 65
equivalent key
equivalent key to COM object, 157
Equivalent key to SCPI command, 111
examples
COM object reference, 157
F
failures, antenna systems, 79
fault location measurement theory, 10
fault location theory, 10
feedline system, antenna, 77
fixed bridge, 24
flush cut, cables which require, 35
flush cut, problems when not, 35
frequency span and distance interactions, 12
Front panel key
Equivalent key to SCPI command, 111
front panel key
equivalent key to COM object, 157
H
hard copy, 87
I
impedance magnitude, 11, 73
impedance, cable, 14
installation and maintenance planning, antenna system, 83
instrument calibration
fault location, 52
SRL, 62
interpreting SRL measurements, 72
K
kinked cable, 31
L
length, connector, 25
M
magnitude, impedance, 11, 73
maintenance and installation planning, antenna system, 83
making fault location measurements, 39
making SRL measurements, 59
measure connector feature, 66
measurement basics, fault location, 10
measurement interpretation
SRL, 72
measurement setup
fault location, 54
SRL, 65
measurement uncertainties, 25
measurements
antenna system installation, 82
antenna system maintenance, 82
antenna systems, 81
before antenna system installation, 82
fault location, 39
SRL, 59
N
non-flush cut cable, 35