Agilent Technologies ESG-D Series - Front Panel (Option 1 EM)

4-10
Assembly Replacement
Front Panel (Option 1EM)
Front Panel (Option 1EM)
Tools Required
• T-10 TORX screwdriver
• T-15 TORX screwdriver
Removal
1. Remove the instrument cover. (Refer to "Instrument Cover" in this chapter.)
2. Remove the top cover by removing the 11 screws that secure it.
3. Disconnect A1W1, A3W1, and W10 from the motherboard (A14). To disconnect W10 you must first unlock the
mo
therboard connector by pulling out the locking mechanism (much like pulling out a drawer).