Agilent Technologies ESG-D Series User Manual

4-22
Assembly Replacement
A1 Front Panel Board
A1 Front Panel Board
Tools Required
• T-10 TORX screwdriver
• 5/16-inch open-end wrench
Removal
1. Remove the front panel assembly. (Refer to "Front Panel" in this chapter.)
2. Remove the small bracket (item 1) that secures W9 (not shown) to the RFI shield (item 2). Disconnect W9.
3. Remove the RFI shield by removing the seven screws (item 3) that secure it.
4. Remove the display (A2) by removing the four screws (item 4) that secure it.
5. Remove the front panel knob (item 5) by pulling it directly away from the front panel.
6. Remove the front panel board (A1) by removing the nine screws (item 6) that secure it.
Replacement
1. Reverse the removal procedure and do the following:
• Torque all T-10 TORX screws to 9 in-lbs.
• Torque W9 to 9 in-lbs.

Agilent Technologies ESG-D Series Specifications

General

Brand	Agilent Technologies
Model	ESG-D Series
Category	Portable Generator
Language	English