36 Advisor Mainframe Features System Guide
4 Attaching/Removing Undercradles
Installing Printed Circuit Cards
You can install up to two printed circuit cards in the
undercradle — full-length or smaller. For full-length cards, you
will need to use the endcap expander. For smaller cards or only
one card, you can use the flat endcap.
1 Gently lift each corner of the connector board to disconnect
it from the standoffs.
2 Turn the connector board over and fasten the card(s) in the
slots provided.
3 Press the connector board onto the standoffs. The cards
should be underneath the connector board as you secure it.
4 Included with your undercradle are seven foam blocks. You
can use them to help stabilize your PC Cards inside the
undercradle.
5 Remove the protector sheet and place the foam block where
needed. It should adhere to the sheet metal and prevent
movement of the cards.
Be sure to follow Electro-Static Discharge (ESD) procedures when
handling any cards.
To Next Page
Loading...
Need help?
General
