Recovering/Re-installing Software 5
Advisor Mainframe Features System Guide 41
Option 506 Option 506 supports three different external hard drives. Check
the ARCHIVES folder on the Advisor software CD if you need to
recreate disks that can be used with your Option 506 external
hard drive.
Items Required to
Upgrade
• Advisor Installation Preparation Disk for HD Recovery
• Sufficient blank 3.5” 1.44 MB diskettes to back up existing
applications, tests, or other data (prior to re-installing
Windows 98)
• BIOS Upgrade Disk, if your BIOS is not current
Read through this entire section before you begin installing
Windows 98.
1 Remove all peripheral hardware (including undercradles) —
you can leave a serial mouse attached.
2 If you have Advisor software loaded and are in the Alternate
Boot Mode, you should return to Windows and properly shut
down before continuing.
3 Insert the Advisor Installation Preparation Disk for HD
Recovery into the floppy drive.
4 Turn on the Advisor and wait while the installation process
sets up and surveys your system. This takes several minutes.
5 Follow the instructions on the screen until Windows setup is
complete (the registration process is completed and the
Windows desktop is displayed).
a If necessary, you will be prompted to upgrade the BIOS
using the BIOS Upgrade Disk. Follow the on-screen
prompts, answering “Y” when prompted to flash the BIOS.
b Once the BIOS upgrade is complete, but before rebooting
the system, remove the BIOS Update Disk from the floppy
drive and re-insert the Installation Preparation Disk.
When ready, press any key to reboot the system, as
prompted by the BIOS Upgrade utility.
When creating an Option 506 disk set, make sure all the disks you create
are copied from the set of images in a single folder. These disks cannot be
mismatched, or problems will be seen.
To Next Page
Loading...
Need help?
General
