Using E4410 E-Series Power Sensors 4
N1913/1914A EPM Series Power Meters User’s Guide 121
Power Meter Configuration
The N1913/1914A EPM Series power meters automatically recognize an
E- Series E4410 power sensor when it is connected. The sensor calibration
data is automatically read by the power meter. Also, the power meter
automatically configures the averaging as shown in Figure 4- 1.
Figure 4-1 E-Series CW sensor auto-averaging settings
10 dB
10 dB
Maximum Sensor Power
Minimum Sensor Power
Power Sensor
Dynamic Range
10 dB
10 dB
1234
1118
Resolution Setting
Number of Averages
11116
11232
1 1 16 256
1 8 128 128
These values are valid only for the power meter channel connected with E-Series E4410
power sensor. Averaging settings can also be manually configured.
To Next Page
Loading...
Need help?
General
