Agilent Technologies N1914a User Manual

10 Specifications and Characteristics
226 Agilent N1913/1914A EPM Series Power Meters User’s Guide
Table 1 0 -5 U2000 Series power sensors specifications
Power sensor Range Zero Drift
1
Measurement Noise
2
U2000/1/2A –60 dBm to –35 dBm 200 pW 1 nW
–38 dBm to –15 dBm 400 pW 1.5 nW
–20 dBm to –9 dBm 1.5 nW 15 nW
–11 dBm to –5 dBm 50 nW 650 nW
–7 dBm to 15 dBm 500 nW 1 µW
10 dBm to 20 dBm 2 µW 10 µW
U2004A –60 dBm to –35 dBm 200 pW 1 nW
–38 dBm to –15 dBm 400 pW 1.5 nW
–20 dBm to –9 dBm 1.5 nW 15 nW
–11 dBm to –5 dBm 50 nW 650 nW
–7 dBm to 15 dBm 500 nW 1 µW
10 dBm to 20 dBm 2 µW 10 µW
U2000/1/2H –50 dBm to –25 dBm 2 nW 10 nW
–28 dBm to –5 dBm 4 nW 15 nW
–10 dBm to 1 dBm 15 nW 150 nW
–1 dBm to 5 dBm 500 nW 6.5 µW
3 dBm to 25 dBm 5 µW10 µW
20 dBm to 30 dBm 20 µW 100 µW
U2000/1B –30 dBm to –5 dBm 200 nW 1 µW
–8 dBm to 15 dBm 400 nW 1.5 µW
10 dBm to 21 dBm 1.5 µW 15 µW
19 dBm to 25 dBm 50 nW 650 µW
23 dBm to 44 dBm 500 µW 1 mW
NOTE
The Zero Drift and Measurement Noise specifications are only applicable to U2000 Series
USB power sensors with serial prefix as shown below:
U2000A Serial prefix MY480/SG480 and above
U2001A Serial prefix MY481/SG481 and above
U2002A Serial prefix MY482/SG482 and above
U2004A Serial prefix MY484/SG484 and above
For power sensors with earlier prefixes, refer to the U2000 Series Operating and Service
Guide.

Agilent Technologies N1914a Specifications

General

Brand	Agilent Technologies
Model	N1914a
Category	Measuring Instruments
Language	English