Agilent Technologies N5161A - Page 61

Agilent N5161A/62A/81A/82A/83A MXG Signal Generators Service Guide
Troubleshooting
The Signal Generator Does Not Power On
1-53
Figure 1-22 Power Supply LEDs
6. Refer to Figure 1-22. Press line switch S1 on the A3 RF assembly.
7. Using Figure 1-22, verify the following A1 Power Supply voltage LEDs are on.
• +3.3VDF, DS1
• +5VDF, DS2
• +5.1VSBF, DS3
• +12VDF, DS4
• +32VAF, DS5
• +5VAF, DS6
• +9VAF, DS7
• +15VAF, DS8
• -7VAF, DS9
• 15VAF, DS10
Front Panel
Rear Panel
Front Panel
Front Panel
Rear Panel
DS8
DS3
DS1
Rear Panel
DS2
DS4
DS9
DS7
DS6
DS10
DS5
S1
深圳德标仪器 135-1095-0799