Key Reference 5
N9342C/43C/44C User’s Guide 131
Meas Setup
Key access: [MODE] > {Power Meter}
Accesses the Meas Disp submenu which is used to
configure the measurement settings.
• Freq
Sets a frequency between 1 kHz and 90.0 GHz
using the numeric keypad, arrow key or knob. If
the frequency does not correspond directly to a
frequency in the sensor calibration table, the
power sensor calculates the calibration factor
using linear interpolation.
• Power Range
Accesses the Power Range submenu.
• Auto Range
Enables and disable auto ranging. When auto
ranging is ON, the power sensor selects the best
measuring range for the measurement. When
auto ranging is OFF, the power sensor remains
in the current range and may be manually set
by the user.
• Range
Selects the Lower or Upper of power ranges
when the Auto Range is Off.
• Limits
Accesses the Limits submenu.
• Limits
Enables or disables the limit function.
• Upper Limit
Sets a value of the upper test limit for the
current measurement. The units used are
dependent on the current setting of power unit.
When the measured power is greater than the
value specified, a failure will be reported.
To Next Page
Loading...
