26
TriScroll 600 Dry Scroll Vacuum Pump
D R A F T 4 / 2 9 / 0 4
20. Heat the inboard housing for a minimum of
1 hour in a 350
o
F oven.
21. Immediately after removing the inboard
housing from the oven, remove the two
bearings, bearing spacer and wave washer
from inboard housing.
22. Use the main bearing extractor tool to push
the bearings out if the bearings do not fall
out.
TriScroll 600 Disassembly (continued)
WARNING This step requires the use
of heat resistant gloves. Do
not proceed without them!
To Next Page
Loading...
