MND172201 P a g e | 55 Software Revision 1.4.1
Appendix B: Optional Sensors
This section describes the optional sensors that can be added to the cart.
Shaft/Speed/Work Switch Sensor-AGSH001
Low RPM Reed Switch Sensor ½” diameter, mounts using ½” P-clip and #10 self-tapping
screw ¾” x 3/16” (included), 3/16” P-clip and #10 self-tapping screw ¾” x 3/16” (included
for securing cable), 2 x magnet .950” x .500” x .125” (included), 20FT cable with 3 pin DTM
series Deutsch connector.
GPS Speed Sensor-9AGPS01/9AGPS02
GPS Speed Sensor 2 ½” diameter, bottom plate on the receiver provides a magnetic mount or
2 x dual lock Velcro (included), 10FT cable with 3 pin DTM series Deutsch connector.
Relay Kit-9KRT069
Relay mounts using #10 self-tapping screw ¾” x 3/16” (included), 2 x Butt splices for
connecting power and ground (included), 1FT cable with 3 pin DTM series Deutsch
connector.
Bare Wire Cable-9ART089
Bare Wire cable allows connection of 3
rd
party sensors White wire power, Red wire signal
and Black wire ground, 4FT cable with 3 pin DTM series Deutsch connector.
To Next Page
Loading...