Aichi SP14DJ - Chapter 1 Safety Rules; Electrocution Hazards; Tip Over Hazards

1
󱒨󱓍󱓆󱓕󱓙󱓊󱓗󱒅󱒖
1. ElectrocutionHazards
DANGER
•Thismachineisnotelectricallyinsulated.
Donotusethemachinenearelectric
powerlines.
M07Y9102
Fig.1‒1
•Keepasafedistancefromelectricpower
linesandapparatus.Forsafedistance,
checkyournationalorlocalregulations.If
nonationalorlocalregulationisavailable,
usethetablebelow.
Table1‒1 MinimumSafeApproachDistance
Voltage
(PhasetoPhase)
MinimumApproach
Distance
0to300V AvoidContact
over300Vto50kV 3.05m
over50kVto200kV 4.60m
over200kVto350kV 6.10m
over350kVto500kV 7.62m
over500kVto750kV 10.67m
over750kVto1000kV 13.72m
•Keepawayfromthemachineifitcontacts
energizedpowerlines.Untilenergized
powerlinesareshutdown,anypersons
intheplatformmustnotoperatethe
machineandanypersonsontheground
mustnottouchthemachine.
WARNING
•Donotusethemachineduringlightning
orstorms.Stopoperationinbadweather.
•Donotusethemachineasagroundfor
welding.
2. TipOverHazards
DANGER
•Donotexceedtheplatformcapacityas
indicatedontheserialnumberplate.
M085E204
Fig.1‒2
•Donotplacethingssuchassteelbeamsor
powerlinesacrosstheplatform,anduse
theboomtoliftthem.
M07Y9603
Fig.1‒3
•Donotusetheboomorplatformto
pushorpullpowerlinesorotherobjects.
Pressingtheboomorplatformhard
againstthemcouldcausethemachineto
tipoverorbedamaged.
SafetyRules
󱒨󱓍󱓆󱓕󱓙󱓊󱓗󱒅󱒖󱒅󱒒󱒅󱒸󱓆󱓋󱓊󱓙󱓞󱒅󱒷󱓚󱓑󱓊󱓘