UG-MD16E-EN (V1.3-190708)
MD-16E
Mixer Reference manual
2.2.7 Configuration
The channel settings configure parameters such as channel name and output delay.
The total navigation bar, click the corresponding
index page or the fader page button on the panel to
quickly switch to the page where the channel is
located.
System setup button, click to enter the system
parameter control page. Same function as the
button on the panel.
Scene button, click to enter the scene control page.
Save or load the scene parameters you need.
Home button, back to the overview channels
page.
Single click to PEQ setup.
Single click to GEQ setup.
Single click to Compressor setup.
Single click to Copy setup.
Single click to Preset setup.
Single click to configuration setup.
Link, the two adjacent MONO channels are linked into a pair of stereo channels.
Only channel linking such as (AUX1, AUX2), (SUB3, SUB4), etc. are supported, and channel linkings such as (AUX2, AUX3), (SUB2, SUB3), etc. are not
supported. The parameters of the odd channel are automatically copied to the even channel when linked, and the phantom power control is also copied.
Channel name, which can be modified by the user,
up to 6 English characters and numbers.
This name will be displayed synchronously on the
guide screen for quick identification by the user.
The delay value of the current output channel is
displayed in different delay units. Delay value
adjustment fader. Delay range: 1.34 ~ 500mS.
The knobs and buttons on the panel
can also be adjusted.
Delay switch, the delay is valid when lighting.
Current channel master control panel, adjustable
gain and mute, etc.
To Next Page
Loading...