- 26 -
USING THIS STATION
Turning on/oႇ visibility enhancement
If the video on the screen is hard to see due to backlight in the
daytime or darkness at night, turn on the visibility
enhancement.
■ To turn on the visibility enhancement
1 Tap .
2 Tap .
The image will be adjusted, a sample is shown below.
Before enhancement
[Day] [Night]
After enhancement After enhancement
Before enhancement
■ To turn oႇ the visibility enhancement
Tap
again.
NOTE:
Visibility of the surveillance camera image cannot be adjusted.
Turning on/oႇ the light control
When the light control is active, the installed light equipment
near the entrance will be lit during receiving a call from the
entrance station or monitoring the entrance station.
■ To turn on the light control
1 Tap .
2 Tap .
■ To turn oႇ the light control
Tap .
NOTE:
This feature may not available depending on the installed system.