- 11 -
PREPARATION
Connecting the station with Wi-Fi
There are two connecting methods available.
• Auto Connect (WPS)
• Manual Setup
• Wi-Fi (Search SSID)
• Wi-Fi (Manual Setup)
• IP Address
Connecting using "Auto Connect (WPS)"
This method connects to a Wi-Fi network using the "Wi-Fi
Protected Setup
TM
" function of a router/STB. Select this
method when it is not required detailed settings.
1 From the MENU screen, tap
ĺ
>
ĺ
Other Settings
.
A con¿ rmation screen will be shown.
2 To continue con¿ guring the settings, tap
9
.
3 Tap
Network
ĺ
9
ĺ
Auto Connect (WPS)
.
4 Press the WPS button on the Wi-Fi router, and
then
tap
9
.
Connection between the residential/tenant station and
Wi-Fi router is established automatically. (In some cases, it
may be necessary to tap
9
before pressing the WPS
button on the wireless router.)
When "The Wi-Fi router has been connected." is shown,
the connection is successful.
If the connection is failed
"Connection failed" will be shown.
Con¿ rm the current network settings and change the settings
properly. (
ĺ
P. 14)
If the connection cannot be established properly, use the
"Manual Setup" method.
* If you connect the station to the Wi-Fi router by using the
"Auto Connect (WPS)" method after the IP address was set
by using "Manual Setup" method, initialization of the user
setting is necessary. (
ĺ
P. 42)
Connecting using "Manual Setup"
Select this method to con¿ gure the detailed settings.
1 Con¿ guring wireless LAN
Con¿ gure the settings for the following items manually.
Item Description
SSID Tapping the entry field displays the keyboard.
(ĺ P. 16)
Use the keyboard to enter the SSID of the wireless
LAN router.
Encryption Tapping the entry field displays the choices. Select
the appropriate encryption method, and tap
9
.
Settings: None / WEP / WPA-PSK(TKIP/AES) /
WPA2-PSK(AES)
Default: WPA2-PSK(AES)
Password Tapping the entry field displays the keyboard.
(ĺ P. 16)
Use the keyboard to enter the password.
* Hexadecimal key format is not supported.
*
When using the keyboard, be sure to tap
9
after ¿ lling
out the entry ¿ eld to determine the contents.
* Do not use the character " and \ for setting the SSID.
1
2
3
1
2
3