AirNav RadarBox Manual
104
Copyright 2010 by AirNav Systems
descending to provide a more realistic view. If it is left unticked, then all 3D models will appear level,
even when climbing and descending.
6. Show Selected Aircraft Balloon for X Seconds - This sets the time for the aircraft information
Balloon (Google Earth information panel) to be displayed before it automatically clears.
7. Show Home Station Location - This setting displays your Home location on the Google Earth
map as set in RadarBox File>Preferences>Home Station Data.
8. Home View: Looking Down From x Feet - This setting controls the 3D View when clicking the
Home button on the RadarBox menu bar. The desired height in feet can be set in the ft box.
9. Home View: Looking Up From Ground View - This selects a ground level view as the Home
view.
Aircraft Selection
1. Show Selected Aircraft as a 3D Model (if available) - If you are using a slower PC and have
set the 3D display not to show 3D aircraft models, this setting allows only the selected aircraft to be
shown in 3D.
2. Keep Previous Trails Visible After New Selections - When an aircraft is selected, a trail behind
the aircraft and down to ground level is displayed. Normally, when a new aircraft is selected, the trail
transfers to the new aircraft. If this option is ticked, then the trail will remain visible on all previously
selected aircraft.
3. Default Number of Aircraft Trail Points - Set the default number of trail points to be displayed.
4. North View on Select - When the aircraft is selected by double-clicking on it in the list, or using
the Go To Aircraft option, the aircraft will be viewed from the front right. If this setting is ticked, then
the view will always be to the north, irrespective of the direction of aircraft flight.
5. Closeup View - If this is selected, the view of the aircraft will be up close.
6. Clear Selection Trails Now - This button clears all trails visible in the 3D View window.
3D View Aircraft Labels
Select the information to be displayed in the aircraft label shown in the 3D view window.
The aircraft label size can be adjusted using the Label Size slider.
3D Data Update Rates
This sets the refresh rate for both hardware detected data (detected by the RadarBox antenna) and
the RadarBox Network data. Reducing the update rate (increasing the time in seconds in the boxes)
will reduce the PC processor loading.
Advanced Settings
To Next Page
Loading...