Airo X Series - Page 2

Use and Maintenance Manual – Series X – XS E RESTYLING
Page 2
Revision date
Description of revision
2010-01
• Update due to new machine directive 2006/42/EC.
• Model names updated.
2010-11
• Biodegradable oil instructions introduced.
• Temperatures and oil list updated.
2011-05
• Amended information on “Commissioning and first inspection, subsequent inspections and
title transfer report”.
• Added “Total quantity of battery electrolyte” in Technical Data.
2012-01
• Overload controller bypass: added reset of leaded seal.
2012-04
• Supplemented with new “XS RESTYLING” series instructions.
2012-09
• Wiring diagram updated.
2013-04
• New model X8 EW WIND added.
• "transport dimensions" updated.
• Amended inclinometer alarm operation description (red light-audible alarm).
2013-10
• Specified instructions for harness anchoring points.
2013-12
• Added sealing check before use of the by-pass connector of the overload controller.
2014-05
• Wiring diagram for replacement of the control box joystick updated.
2014-06
• Added new model X14 EW NP.
• Added emergency lowering from the ground and the platform with manual pump.
2014-09
• Inserted information on maximum limits of manual forces.
• Changed Name and Surname of CEO.
2015-01
• CE conformity declaration updated.
• Added position of hands instruction
2015-10
• Type of usable hydraulic oil updated.
• Added indication for spare parts. They must be original or approved by the manufacturer of
the machine in any way.
• Added "Leaving at height”.
2016-01
• Inclinometer alarm description updated.
• Overload alarm description updated.
• Added new load control system description.
• Added new model XS8 E – RESTYLING WIND
2017-02
• Added instructions of load control with pressure switch.
2017-05
• Added new model X14 EN.
2017-08
• Added new model X16 EW.
• Updated technical details XS SERIES: wheel dimensions updated.
2018-05
• Data sheets were added with units of measurement of the international system and US unit
of measurement.
• Changed Name and Surname of CEO.
2019-07
• Updated procedure description of commissioning declaration in Italy.
2019-10
• Added hydraulic scheme X16 EW.
2019-12
• Added procedure for sectioned rails.
2020-01
• Updated normative references and Notified Body’s name
• Removed references and procedures about sectioned rails.
• Removed model X14 EW NP