Use and Maintenance Manual – Series X – XS E RESTYLING
5.6 Manual emergency lowering
IT IS FORBIDDEN
to use the manual emergency lowering control to lower the platform with overloads.
5.6.1 Manual emergency lowering Standard control
5-6: Manual emergency lowering with one knob
5-7: Manual emergency lowering with two knobs
In case of fault in the electric or hydraulic system, to carry out the manual emergency lowering procedure pull out
the knob indicated in the (Figure 5-6).
Where two knobs are present, these should be activated both of them according to the sequence shown in the plate (Figure 5-7).
Caution, the emergency control can be stopped at any time by releasing the knob.
This function is to be used only in emergency situations when no motive power is available.
To Next Page
Loading...
