Airo X Series - General Maintenance Schedule

Use and Maintenance Manual – Series X – XS E RESTYLING
Page 68
7.2 Machine cleaning
To clean the machine use non-pressurized water jets after properly protecting the following parts:
▪ The control panels (both platform and ground)
▪ All electric boxes and electric devices in general
▪ The electric motors
Do not use pressurized water jets (e.g. high-pressure cleaners) to clean the machine.
After washing the machine, always:
▪ Dry the machine.
▪ Check integrity of plates and stickers.
▪ Lubricate the articulated joints equipped with greaser and the sliding ways.
7.3 General maintenance
Below are listed the main maintenance jobs to be done and the relevant schedule (the machine features an hour meter).
OPERATION
FREQUENCY
Screw tightening (paragraph "Various adjustments”)
After the first 10 working
hours
Oil level check in hydraulic tank
After the first 10 working
hours
Battery state (charge and liquid level)
Every day
Deformation of tubes and cables
Every month
Stickers and code plates
Every month
Articulated joints / sliding blocks greasing
Every month
Oil level check in hydraulic tank
Every month
Emergency devices efficiency check
Every year
Electric connections check
Every year
Hydraulic connections check
Every year
Periodic operation check and structure visual check
Every year
Screw tightening (paragraph "Various adjustments”)
Every year
Pressure relief valve calibration check
Every year
Lifting circuit pressure relief valve calibration check
Every year
Braking valve efficiency check
Every year
Inclinometer operation check
Every year
Platform overload controller operation check
Every year
M1 microswitch operation check
Every year
MPT1 and MPT2 microswitches operation check
Every year
Dead-man switch check efficiency
Every year
Total oil change in hydraulic tank
Every two years
Hydraulic filter replacement
Every two years
IT IS NECESSARY
TO SEND THE MACHINE TO THE MANUFACTURER WITHIN 10 YEARS OF WORK
WITHIN 10 YEARS OF WORK.