40
Timer. It is an auto power-off timer of the zone.
Off. Timer is not activated.
30. It activates the timing and switches off the zone after 30 minutes.
60. It activates the timing and switches off the zone after 60 minutes.
90. It activates the timing and switches off the zone after 90 minutes.
Information. This parameter provides information about:
• Zone: firmware, zone, association, actuator or communication status.
• System: firmware, settings and information about the system controllers.
• Devices: displays the elements connected to the system.
• Webserver (Only for system 1 Main thermostat): firmware, IP address, gateway, MAC and PIN.
Main zone. This parameter is only available when the Main thermostat of the group is lost. Enables to access and to modify the
operation mode of the group.
To Next Page
Loading...
