Changing the default name for a track
Usually, when you create a new track, the name will be automatically set as default “Track## (## indicates track
number). You can change the default track name.
01. In the MAIN page, select the Tr field.
02. Press the [WINDOW] key.
The Track window will open.
03. In the Default name field, enter the new name.
For more information about setting the name, see the “Setting the name” section on Page 8.
04. Press [F4] (CLOSE) key.
This closes the window and goes back to the MAIN page.
Copying a track
You can copy a track to another track.
01. In the Tr field of the MAIN mode, select a track to copy.
02. Press the [WINDOW] key.
The Track window will open.
03. Press [F5] (COPY) key.
The Copy Track window will open.
04. In the Tr field (below), select a track to copy to.
05. Press [F3] (DO IT) key.
Copying the sequence will start. To cancel the operation, press [F4] (CANCEL) key.
Deleting a track
You can remove a track from the memory of the MPC1000.
1. In the Tr field in MAIN mode, select a track to delete.
2. Press the [WINDOW] key.
The Track window will open.
3. Press [F2] (DELETE) key.
The Delete Track window will open.
4. Press [F5] (DO IT) key.
That deletes the selected track and changes its name to “unused”.
Deleting all tracks
You can delete all the track data in the memory at one time.
01. In the MAIN mode, select the Tr field and press the [WINDOW] key.
The Track window will open.
02. Press [F2] (DELETE) key.
The Delete Track window will open.
03. Press [F3] (ALL TR) key.
The Delete ALL Tracks window will open.
04. Press [F5] (DO IT) key.
That deletes all the tracks and changes their names to “unused”.
To Next Page
Loading...
Need help?
General
