Chapter 14 : Effect
In this section, you will learn how to select and edit effects. The MPC1000 has two stereo effects and one master
effect. To apply the effects to a specific pad sound, use the two stereo effects. To apply effects to the entire
sound, use the master effect.
Note: The effect settings will be saved with the ALL file, which is created when you save the data by selecting
SAVE ALL SEQS & SONGS.
Applying effects to a specific pad sound
You can apply effects to the selected pad sound. Here, let’s apply BIT GRUNGER to the selected pad sound.
01. Press the [MODE] key and then the [PAD 12] (EFFECT).
The EFFECT mode will be displayed.
02. Press the [F1] (SELECT) key.
The SELECT page will be displayed.
03. Move the cursor to the FX1 type field and turn the DATA wheel, or press the [WINDOW]
key.
The Select Effect window will be displayed. You can select the effect type by turning the DATA wheel.
04. Select BIT GRUNGER and press the [F5] (SELECT) key.
This closes the window and goes back to the SELECT page.
BIT GRUNGER is selected in the FX1 type field.
05. Press the [MODE] key and then the [PAD 8] (MIXER) to display the MIXER mode.
You select the pad for the effect in the MIXER mode.
06. Press the [F3] (FXSEND) key.
The FX SEND page will be displayed.
07. Hit the desired pad.
This pad will be selected and its display will be highlighted.
08. Press the UP cursor key to select the FX Send field.
The FX Send field for the effect setting will be selected.
OF No effect will be applied to the pad.
1 The effect of the FX1 will be applied to the pad.
2 The effect of the FX2 will be applied to the pad.
Here, select 1.
When you hit the selected pad, the processed sound will be played.
The effected sound will be output from the stereo out.
Tips: you can apply the effect to several pads. The effect of the FX 1 is applied to all the pads whose FX SEND are
set to 1 In the FX SEND page of the MIXER mode.
Tips: you can set the effects in details. For more information about detailed editing of each effect, see the “Editing
effects” section.
Note: You cannot apply the effects to the pads whose outputs are NOT set to ST (stereo out) in the L/OUT page of
the MIXER mode.
Like FX 1, you can use the effects of the FX 2 by selecting an effect in the FX2 type field of the SELECT page in the
MIXER mode and setting the FX SEND field to 2 in the FX SEND page of the MIXER mode.
To Next Page
Loading...
Need help?
General
