Creating the Autoload folder
When you create an AUTOLOAD folder on the memory card, the MPC1000 will load the contents of the
AUTOLOAD folder automatically when you switch on the unit with the memory card in the card slot. You can load
the most frequently used drum set program or sequence data automatically.
01. In the Type field, select SAVE ENTIRE MEMORY.
AUTOLOAD folder will be created in the ROOT folder, which is located at the top directory, so you do not
have to select the destination folder.
02. Press the [F6] (DO IT) key.
The Save Entire Memory window will be displayed.
03. Press the [F2] (A.LOAD) key.
The Save Auto load File window will be displayed.
04. Press the [F5] (DO IT) key.
The MPC1000 will create the AUTO LOAD folder in the ROOT folder and save all the data in that folder.
If the ROOT folder already has the AUTOLOAD folder, the Autoload Folder Exists window will be displayed.
To replace the current AUTO LOAD folder with a new one, press the [F2] (REPLAC) key. In this case, the
contents of the current AUTOLOAD folder will be deleted.
To keep the current AUTOLOAD folder, press the [F4] (CANCEL) key to cancel the operation, go to the
Directory folder and change the name of the current AUTOLOAD folder.
Loading a file
In this section, you will learn how to load a file
from the memory card. This is done in the LOAD
page, which is accessed by pressing the [MODE]
key and then the [PAD 2] (LOAD).
Selecting a file
To select a file to load, proceed as follows:
01. Press the [MODE] key and the [PAD 2] (LOAD).
The LOAD page will be displayed. To load a file from the memory card, insert the compact flash card in the
memory card slot.
Note: Make sure that you insert the compact flash card completely in the slot.
02. Select the LOAD from field and select the memory you wish to load the data from.
INTERNAL MEMORY The MPC1000 will load the data from the internal preset memory. Normally, when you
switch on the MPC1000, it will load the data from the preset memory, but you can
load these files individually by selecting INTERNAL MEMORY in this field.
MEMORY CARD The MPC1000 will load the files from the memory card in the card slot.
03. Select the folder field or File field, and press the [WINDOW] key.
The Directory window will be displayed. You can also select a file in the folder, and in the File field of the
LOAD page, but it is easier to use the Directory window, which displays the files in the list.
In the Directory window, you can browse the files in
the memory. The files in the memory card are saved
in the directories hierarchically, like the other
computer files.
To Next Page
Loading...
Need help?
General
