Tips: The output setting is made by stereo pairs. If you wish to output four monaural signals separately from the
four assignable mix outs, use the pan settings in the L/PAN page. For example, to use the assignable mix out
1/2 as two mono outs, in the L/OUT page, set the output to 1/2 and set the pan setting of the pad you wish to
output from the out 1 and 2 to L and R respectively.
Selecting the pad to apply the effect
With the MPC1000, you can apply two effects to one pad sound. To apply effects, you need to set the pad’s
sample to be sent to the effect section. In this section, you will learn how to send the pad sound to the effect
section.
Tips: This picture displays the signal flow of the sample sound to the stereo out through the effect section. As you
can see in this picture, you can apply the effects only to the pads whose outputs are set to the stereo out.
You cannot apply the effects to the pads whose outputs are set to the assignable mix outs.
01. In the MIXER mode, press the [F3] (FXSEND) key.
The FX SEND page will be displayed.
Each column indicates pad 1 though 16 from the left and the currently selected pad is highlighted. The
display at the top indicates the output setting. The bar display on the bottom indicates the current send level.
The level setting is the same as the setting in the L/PAN page.
02. Hit the desired pad.
The lane of the selected pad will be highlighted.
03. Press the UP cursor key.
The FX Send field for the effect setting will be selected. You can change the setting by turning the DATA
wheel.
OF No effect will be used.
1 The effect 1 will be used. The Pad sound will be sent to the FX1 of the effect section.
2 The effect 2 will be used. The Pad sound will be sent to the FX2 of the effect section.
To Next Page
Loading...
Need help?
General
