Connecting the MPC1000 to the Macintosh
01. Insert the memory card to the MPC1000’s card slot.
02. Press the [MODE] key and then the [PAD 2] (LOAD), or [PAD 3] (SAVE).
03. In the LOAD page, or the SAVE page, press the [F4] (USB) key.
This brings up the USB page, which you use to connect the MPC1000 to the PC. That is all for the MPC1000.
04. Connect the MPC1000’s USB slave jack to your computer’s USB host jack via USB
cable.
05. Removal media will be displayed on the desktop.
To save the data in the computer, select the data and drag and drop it from the removable disk to the hard
disk. To load the data from the computer, select the data and drag and drop it from the hard disk to the
removal media.
06. After you finish the data transfer, select the removable media and drag and drop to the
trash can.
When you drag the removal media to the Dock’s recycle bin under Mac OS 10.x, the icon will change to the
eject icon.
07. Remove the USB cable from the USB jacks of the MPC1000 and the computer.
Note: Make sure that you do Step 06 before disconnecting the USB page.
Note: You can transfer the data between the MPC1000 and the PC only when the USB page is displayed.
You can not move to another page or mode from USB page unless you disconnect the USB cable.
To Next Page
Loading...
Need help?
General
