Chapter 17 : Other settings
In this section, you will learn about the other features, which were not mentioned in the other chapters.
Foot switch
You can connect up to 2 foot switch to the MPC1000 and assign several functions (ex. Start/Stop a sequence, etc
…) to them.
01. Connect a foot switch to the MPC1000’s FOOTSWITCH jack.
02. Press the [MODE] key, and then the [PAD 10] (OTHER).
You will enter to the OTHER mode.
03. Press the [F3] (FOOTSW) key.
This brings up the FOOTSW page, where you can make settings for the foot switch.
04. Select the function to assign to the foot switch 1 in the Footswitch 1 field, and the
function to assign to the foot switch 2 in the Footswitch 2 field.
You can select the following functions.
PLAY START It works the same as the PLAY START key.
PLAY It works the same as the PLAY key.
STOP It works the same as the STOP key.
PLAY/STOP When you step on the switch in stop mode, the MPC1000 will start the playback.
When you step on the switch in play mode, the MPC1000 will stop the playback.
REC+PLAY It works as the same when you press the REC key and the PLAY key
simultaneously (recording).
OVER DUB+PLAY It works as the same when you press the OVER DUB and PLAY key
simultaneously (overdub).
REC/PUNCH When you step on the switch in stop mode, the MPC1000 will start the playback,
when you step on the switch in play mode, it starts recording, in recording mode, it
starts playback.
OVER DUB/PUNCH When you step on the switch in stop mode, the MPC1000 will start the playback,
when you step on the switch in play mode, it starts overdubbing, in overdub mode,
it starts playback.
TEMPO TAP It works the same as the TEMPO/NOTE REPEAT key.
PAD1 through 16 The MPC1000 will play the selected pad at the fixed velocity of 127 (maximum).
F1 through F6 They work the same as the function keys 1 through 6.
PAD BANK A through D They work the same as the PAD BANK keys.
To Next Page
Loading...
Need help?
General
