Copying a program
You can copy a program to make a new program.
01. In the Pgm field in PROGRAM mode, select the program that you wish to copy.
02. Press the [WINDOW] key.
The Program window will open.
03. Press [F5] (COPY) key.
The Copy Program window will open.
04. In the New name field, set the name for the new program.
For more information regarding setting the name, see the “Setting names” section on Page 8.
05. Press [F3] (DO IT) key.
Copying the program will start. To cancel the operation, press [F4] (CANCEL) key instead.
Deleting a program
You can remove a program from the memory of the MPC1000.
01. In the Pgm field in PROGRAM mode, select the program that you wish to delete.
02. Press the [WINDOW] key.
The Program window will open.
03. Press [F2] (DELETE) key
The Delete Program window will open.
04. Press [F5] (DO IT) key.
This deletes the selected program.
Deleting all programs
You can delete all the program data in the memory at the same time.
01. In the PROGRAM mode, select the Pgm field and press the [WINDOW] key.
The Program window will open.
02. Press [F2] (DELETE) key.
The Delete Program window will open.
03. Press [F3] (ALL PG) key.
The Delete ALL Programs window will open.
04. Press [F5] (DO IT) key.
This deletes all the programs.
Setting the program change number
You can switch the programs assigned to a track within the sequence by setting the program change numbers in
each program. You do not have to set the program change numbers if you do not need to switch the programs .
To switch the programs, program change events are used. You can enter these events in the STEP EDIT mode.
For more information about entering the program change events, see the “Step editing” section on page 30.
01. In the Pgm field of the PROGRAM mode, press the [WINDOW] key.
The Program window will be displayed.
02. Select the MIDI program change field and set the program change number.
If a track has a program change event with the same number set in this field, the MPC1000 switches the
program at the event while playing back the sequence. If you do not wish to switch the program during the
playback, set this field to OFF.
To Next Page
Loading...
Need help?
General
