Acceptance test recommendations 20 (38)
Installation Manual T-Rx 1000/1500 FSK12 FSK12 Version: B4 Document-ID: 945814-000 Author: SH
9.5.4 Radio coverage area
Activate the system.
Check that the driver with an activated system may keep the system activated within the
expected area.
10 Acceptance test recommendations
As the way the set of outputs is used for controlling the vehicle/machine (for instance for
driving the engine and the brakes of the vehicle/machine or controlling other vehicle/machine
assemblies) depends on the specic installation and is out of the scope of the T-Rx 1000/1500
receiver no vehicle/machine functionality tests are described in this test plan.
However the following general test recommendations should be considered:
• Test that each RCSS output will generate a stop.
• Test that all commands performed on the transmitter performs the expected response on
the controlled vehicle/machine.
For tuning of outputs a software tool for parameter setting is available, T-Rx 1500 PRM Manag-
er. With this tool min and max values, ramp times, progressivity and movement directions may
be set for each output.
The program runs on a PC and is connected to the T-Rx 1500 receiver via USB.
11 Decommissioning of equipment
The receiver shall be treated as electronic waste and disposed of according to legal regulation or
law. Contact therefore your local environmental authority or your waste disposal company.
11.1 Removal of receiver
Before decommissioning contact the remote control integrator to check if any modication is
necessary on the vehicle/machine control unit/control equipment when removing the remote
control.
Disconnect and remove all cabling between the receiver and the control unit/equipment on the
vehicle/machine.
Disconnect and remove the antenna cabling to the receiver. If also the antennas are removed be
sure to secure the vehicle/machine chassis against water leakage.
Remove the receiver unit from the vehicle/machine.
To Next Page
Loading...
