Akuvox A02 Administrator's Guide

Akuvox A02 Access Control Terminal Admin Guide
www.akuvox.com
12
5 Access the Device
Before configuring Akuvox A02, please make sure the device is installed correctly and
connects to a normal network. Using the Akuvox IP scanner tool to search the device IP
address in the same LAN. Then use the IP address to log in to the web browser by user
name and password admin and admin.
You can obtain the IP address by pressing the Reset button at the back of the device. And
you can also set the number of IP number announcement (1-5 times) if needed. You can
go to Device > Audio > IP Announcement.

Akuvox A02 Specifications

General

Interface	Ethernet
Case design	-
Event capacity	100000
Number of users	20000 user(s)
Card holders quantity	20000
Maximum number of doors	1 door(s)
Supported network protocols	IPv4, HTTP, HTTPS, FTP, SNMP, DNS, NTP, RTSP, RTP, TCP, UDP, ICMP, DHCP, ARP
Ethernet LAN data rates	10, 100 Mbit/s
DC voltage range	12 V
Power consumption	600 mA
Ethernet LAN (RJ-45) ports	1
Storage temperature (T-T)	-30 - 70 °C
Operating temperature (T-T)	-20 - 55 °C
Operating relative humidity (H-H)	10 - 90 %

Weight and Dimensions

Depth	33 mm
Width	86 mm