Akuvox A02 Administrator's Guide

Akuvox A02 Access Control Terminal Admin Guide
www.akuvox.com
32
12.7 Access Authentication Mode
12.7.1 Access Authentication Mode Configuration
A02 supports dual access authentication mode. You can set up the dual access
authentication mode on Access Control > Relay> Access Authentication Mode interface.
Parameter Set-up:
• Authentication Mode: Any Method indicates RF card or PIN code.RF Card+PIN
means swiping the card first and then pressing the PIN code. PIN+RF Card means
press PIN code, then swipe the card.
12.7.2 Dual Authentication Interval
You can set up the interval time for dual access authentication on Access Control >
Keypad interface.
Parameter Set-up:
• Enter Interval(Sec): set up the interval time from 1 to 10 seconds. For example, if you
set the interval time as 5 seconds, then the interval between the two access
authentication must be limited to 5 seconds.

Akuvox A02 Specifications

General

Interface	Ethernet
Case design	-
Event capacity	100000
Number of users	20000 user(s)
Card holders quantity	20000
Maximum number of doors	1 door(s)
Supported network protocols	IPv4, HTTP, HTTPS, FTP, SNMP, DNS, NTP, RTSP, RTP, TCP, UDP, ICMP, DHCP, ARP
Ethernet LAN data rates	10, 100 Mbit/s
DC voltage range	12 V
Power consumption	600 mA
Ethernet LAN (RJ-45) ports	1
Storage temperature (T-T)	-30 - 70 °C
Operating temperature (T-T)	-20 - 55 °C
Operating relative humidity (H-H)	10 - 90 %

Weight and Dimensions

Depth	33 mm
Width	86 mm