Akuvox A02 Administrator's Guide

Akuvox A02 Access Control Terminal Admin Guide
www.akuvox.com
33
13 Security
13.1 Tamper Alarm Setting
The tamper alarm function serves as a protection against any unauthorized removal of the
devices by triggering off the temper alarm on the device. To configure the configuration on
web System > Security > Tamper Alarm interface.
Parameter Set-up:
• Enabled: enable the anti-theft alarm function.
• Gravity Sensor Threshold: set the threshold for gravity sensory sensitivity. The lower
the value is, the more sensitive the sensor will be. The gravity sensor value is 32 by
default.
13.2 Security Notification Setting
13.2.1 Email Notification Setting
If you want to receive the security notification via E-mail, you can configure the E-mail
notification on the web interface properly. To configure the configuration on web Setting >
Action > Email Notification interface.

Akuvox A02 Specifications

General

Interface	Ethernet
Case design	-
Event capacity	100000
Number of users	20000 user(s)
Card holders quantity	20000
Maximum number of doors	1 door(s)
Supported network protocols	IPv4, HTTP, HTTPS, FTP, SNMP, DNS, NTP, RTSP, RTP, TCP, UDP, ICMP, DHCP, ARP
Ethernet LAN data rates	10, 100 Mbit/s
DC voltage range	12 V
Power consumption	600 mA
Ethernet LAN (RJ-45) ports	1
Storage temperature (T-T)	-30 - 70 °C
Operating temperature (T-T)	-20 - 55 °C
Operating relative humidity (H-H)	10 - 90 %

Weight and Dimensions

Depth	33 mm
Width	86 mm