Akuvox A02 Administrator's Guide

Akuvox A02 Access Control Terminal Admin Guide
www.akuvox.com
34
Parameter Set-up:
• Sender's Email Name: enter the name of the email sender.
• Sender's Email address: enter the sender's email address from which the email
notification will be sent out.
• Receiver's Email address: enter the receiver's email address.
• Receiver's Email Name: enter the name of the email receiver.
• SMTP Server Address: enter the SMTP server address of the sender.
• Port: enter the port number from which the email is sent out.
• SMTP User Name: enter the SMTP user name, which is usually the same as the
sender's email address.
• SMTP Password: configure the password of the SMTP service, which is the same as
the sender's email address.
• Email Subject: enter the subject of the email.
• Email Content: compile the email contents according to your need.
• Email Test: click to test if the email can be sent and received.

Akuvox A02 Specifications

General

Interface	Ethernet
Case design	-
Event capacity	100000
Number of users	20000 user(s)
Card holders quantity	20000
Maximum number of doors	1 door(s)
Supported network protocols	IPv4, HTTP, HTTPS, FTP, SNMP, DNS, NTP, RTSP, RTP, TCP, UDP, ICMP, DHCP, ARP
Ethernet LAN data rates	10, 100 Mbit/s
DC voltage range	12 V
Power consumption	600 mA
Ethernet LAN (RJ-45) ports	1
Storage temperature (T-T)	-30 - 70 °C
Operating temperature (T-T)	-20 - 55 °C
Operating relative humidity (H-H)	10 - 90 %

Weight and Dimensions

Depth	33 mm
Width	86 mm