Akuvox A02 Administrator's Guide

Akuvox A02 Access Control Terminal Admin Guide
www.akuvox.com
17
8 Volume and Tone Configuration
Volume and tone configuration in A02 access control terminal refers to tamper alarm
volume, voice prompt volume, and open-door tone configuration. Moreover, you can
upload the tone you like to enrich your personalized user experience.
8.1 Volume Configuration
You can configure the Mic volume according to your need for open-door notification.
Moreover, you can also set up the tamper alarm volume when unwanted removal of the
access control terminal occurs. To configure the configuration on web Device > Audio >
Volume Control interface.
Parameter Set-up:
• Tamper Alarm Volume: set the tamper alarm volume from 0-15 according to your
need. The default volume is 8.
• Voice Prompt Volume: set the voice prompt volume from 0-15 according to your
need. The default volume is 8.
• Keypad Volume: adjust the volume of the keypad. The default volume is 8.

Akuvox A02 Specifications

General

Interface	Ethernet
Case design	-
Event capacity	100000
Number of users	20000 user(s)
Card holders quantity	20000
Maximum number of doors	1 door(s)
Supported network protocols	IPv4, HTTP, HTTPS, FTP, SNMP, DNS, NTP, RTSP, RTP, TCP, UDP, ICMP, DHCP, ARP
Ethernet LAN data rates	10, 100 Mbit/s
DC voltage range	12 V
Power consumption	600 mA
Ethernet LAN (RJ-45) ports	1
Storage temperature (T-T)	-30 - 70 °C
Operating temperature (T-T)	-20 - 55 °C
Operating relative humidity (H-H)	10 - 90 %

Weight and Dimensions

Depth	33 mm
Width	86 mm