Akuvox A02 Administrator's Guide

Akuvox A02 Access Control Terminal Admin Guide
www.akuvox.com
28
Note
• RF card with 13.56 MHz and 125 kHz can be applicable to the access control
terminal for door access.
12.1.2 Configure RF Card Code Format
If you want to integrate with the third-party intercom system in terms of RF card door
access, you can change the RF card code format to be identical to that applied in the third-
party system. To configure the configuration on the web Access Control > Card Setting
>RFID interface.
Parameter Set-up:
• IC/ID Card Display Mode: select the card format for the ID Card for the door access
among five format options: 8H10D; 6H3D5D (W26); 6H8D; 8HN; 8HR. The card code
format is 8HN by default in the access control terminal.
12.2 Unlock by NFC
NFC (Near Field Communication) is a popular way for door access. It uses radio waves for
data transmission interaction. A02 can be unlocked by NFC. You can keep the mobile
phone closer to the door phone for door access. To configure the configuration on web
Access Control > Card Setting > Contactless Smart Card interface.

Akuvox A02 Specifications

General

Interface	Ethernet
Case design	-
Event capacity	100000
Number of users	20000 user(s)
Card holders quantity	20000
Maximum number of doors	1 door(s)
Supported network protocols	IPv4, HTTP, HTTPS, FTP, SNMP, DNS, NTP, RTSP, RTP, TCP, UDP, ICMP, DHCP, ARP
Ethernet LAN data rates	10, 100 Mbit/s
DC voltage range	12 V
Power consumption	600 mA
Ethernet LAN (RJ-45) ports	1
Storage temperature (T-T)	-30 - 70 °C
Operating temperature (T-T)	-20 - 55 °C
Operating relative humidity (H-H)	10 - 90 %

Weight and Dimensions

Depth	33 mm
Width	86 mm