Akuvox A02 Administrator's Guide

Akuvox A02 Access Control Terminal Admin Guide
www.akuvox.com
23
11 Door Access Schedule Management
You are required to configure and make a schedule for the user-based door access via RF
card, and private PIN.
11.1 Configure Door Access Schedule
You can create door access schedules so that they can be later conveniently applied to the
door access control intended for individual users or a group of users created. Moreover,
you can edit your door access schedule if needed.
11.1.1 Manage Relay Schedule
Set the corresponding relay always open at a specific time. This feature is designed for
some specific scenarios, for example, the time after school, or for morning work time. To
do the configuration on the web Access Control > Relay > Relay Schedule interface.
Parameter Set-up:
• Relay ID: choose the relay you need to set up.
• Schedule Enable: enable the relay schedule.

Akuvox A02 Specifications

General

Interface	Ethernet
Case design	-
Event capacity	100000
Number of users	20000 user(s)
Card holders quantity	20000
Maximum number of doors	1 door(s)
Supported network protocols	IPv4, HTTP, HTTPS, FTP, SNMP, DNS, NTP, RTSP, RTP, TCP, UDP, ICMP, DHCP, ARP
Ethernet LAN data rates	10, 100 Mbit/s
DC voltage range	12 V
Power consumption	600 mA
Ethernet LAN (RJ-45) ports	1
Storage temperature (T-T)	-30 - 70 °C
Operating temperature (T-T)	-20 - 55 °C
Operating relative humidity (H-H)	10 - 90 %

Weight and Dimensions

Depth	33 mm
Width	86 mm