Akuvox A02 Administrator's Guide

Akuvox A02 Access Control Terminal Admin Guide
www.akuvox.com
16
7 LED Setting
7.1 Brightness Setting
If you want to brighten up the brightness in order to see the card reader at greater ease in
an environment with higher light intensity, you need to set up the related parameters in the
web Device >Light > Light of Swiping Card Area.
Parameter Set-up:
• Backlight Intensity: adjust the backlight intensity, the bigger value, the brighter
backlight.
• Backlight Enabled: enable the card reader LED lighting if needed.
• Start Time - End Time (H): enter the time span for the LED lighting to be valid, e.g., if
the time span is from 18-22 it means the LED light will stay on during the time span
from 6:00 pm to 10:00 pm in one day (24 hours).

Akuvox A02 Specifications

General

Interface	Ethernet
Case design	-
Event capacity	100000
Number of users	20000 user(s)
Card holders quantity	20000
Maximum number of doors	1 door(s)
Supported network protocols	IPv4, HTTP, HTTPS, FTP, SNMP, DNS, NTP, RTSP, RTP, TCP, UDP, ICMP, DHCP, ARP
Ethernet LAN data rates	10, 100 Mbit/s
DC voltage range	12 V
Power consumption	600 mA
Ethernet LAN (RJ-45) ports	1
Storage temperature (T-T)	-30 - 70 °C
Operating temperature (T-T)	-20 - 55 °C
Operating relative humidity (H-H)	10 - 90 %

Weight and Dimensions

Depth	33 mm
Width	86 mm