Akuvox R28 Series - Network; 1.DHCP Mode; 2.Static IP Mode

R28A/V
Admin Guide
3.4.3.Network
3.4.3.1.DHCP Mode
At device side, press “*2396#” to enter administrator interface.
Press “3” to enter system setting interface, and press “1” to enter
network setting interface.
Select DHCP mode, and R28 will access network automatically.
In website, go to Network - Basic.
R28 uses DHCP mode by default which will get IP address,
subnet mask, default gateway and DNS server address from
DHCP server automatically.
3.4.3.2.Static IP Mode
At device side, press “*2396#” to enter administrator interface.
Press “3” to enter system setting interface, and press “1” to enter
network setting interface.
Figure 3.4.3.1 DHCP mode
Figure 3.4.3.2 Static IP mode