An amplifier is operating outside of the normal operating range. The ingress power to the
amplifier plus the programmed gain (both in dB's) has exceeded the maximum allowable
output power supported by the amplifier. This can occur only if the amplifier output
power limiting function and the output overload function have both failed.
Severity Minor
Service affecting? No
Applicability A2325A, AHPHG, AHPLG, ALPHG, ALPFGT, AM2017B,
AM2325B
Corrective Action
None. This is a transitory alarm that is raised for a maximum of 30 seconds while the
amplifier attempts to limit the output power. If after 30 seconds the output power cannot
be limited, a “CONTEQPT (Card Failure - Device)” (p. 2-54) alarm is raised.
Trouble-clearing procedures
HIGAIN
HIGAIN (Amplifier Out of Operational Range: Gain too High)
....................................................................................................................................................................................................................................
....................................................................................................................................................................................................................................
1830 PSS-36/PSS–32/PSS-16/PSS-4
8DG60888CAAA Release 3.6.0 and 3.6.1
Issue 1 June 2011
2-111
To Next Page
Loading...
