EasyManua.ls Logo

Alcatel-Lucent 1830 PSS-16 - Page 516

Alcatel-Lucent 1830 PSS-16
722 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Corrective Action
At the end of each step wait to see if the fault clears. If not, continue with the next step.
...................................................................................................................................................................................................
1
Perform a power adjust operation at the ingress amplifier card or the ALPHG card that
has raised the PWRADJREQ alarm.
CLI config powermgmt
ingress | egress shelf slot
...................................................................................................................................................................................................
2
If... Then...
the adjustment is successful, the PWRADJREQ alarm will be cleared.
Continue with Step 3.
the
adjustment fails, the PWRADJFAIL alarm will appear. Proceed
to “PWRADJFAIL” (p. 2-257).
...................................................................................................................................................................................................
3
Follow the appropriate procedures in the Alcatel-Lucent User Provisioning Guide to
validate the set parameters of the network per the Network Plan.
PWRMARGIN
PWRMARGIN (Power Adjust Loss Margin Exceeded)
This condition is raised as a result of the gain, required to increase the power level at the
ingress port of an LD amplifier, being close to the maximum value as set by the
Engineering and Planning Tool (EPT). Without the ability to increase the gain any further,
the repair margin has been compromised and any additional loss would result in
power-adjust alarms.
Severity Minor
Service affecting? No
Applicability A2325A, AHPHG, AHPLG, ALPHG, ALPFGT, AM2017B,
AM2125A, AM2125B, AM2325B, OSCT
Trouble-clearing procedures
PWRADJREQ
PWRADJREQ (Power Adjust Required)
....................................................................................................................................................................................................................................
....................................................................................................................................................................................................................................
2-266
1830 PSS-36/PSS–32/PSS-16/PSS-4
8DG60888CAAA Release 3.6.0 and 3.6.1
Issue 1 June 2011
E ND OF STEPS
...................................................................................................................................................................................................

Table of Contents

Related product manuals